1962 front drums and ball bearings - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Rezzato · 08-15-2009, 01:39 PM

The inner and outer ball bearings went out on my 1962 C/20. They are extremely expensive to replace. My question is that if i were to get the drums and wheel bearings off of a 1963-1966 would they slide right onto the spindle of the 62? What is the best way to take care of this without spending 150 bucks on new bearings?

fleetsidelarry · 08-15-2009, 04:23 PM

quick search of our forum found this:

http://67-72chevytrucks.com/vboard/s...wheel+bearings

I'm not sure if the swap info applies to 3/4 ton, but you may be able to match bearing numbers cheaper than NAPA, as one poster suggests. Here's another good thread:

http://67-72chevytrucks.com/vboard/s...wheel+bearings

Larry

08-15-2009, 01:39 PM	#1
Rezzato Registered User Join Date: Sep 2008 Location: Los Angles CA Posts: 30	1962 front drums and ball bearings The inner and outer ball bearings went out on my 1962 C/20. They are extremely expensive to replace. My question is that if i were to get the drums and wheel bearings off of a 1963-1966 would they slide right onto the spindle of the 62? What is the best way to take care of this without spending 150 bucks on new bearings?

08-15-2009, 04:23 PM	#2
fleetsidelarry Senior Car Nut Join Date: Jan 2008 Location: shellman bluff, GA Posts: 1,411	Re: 1962 front drums and ball bearings quick search of our forum found this: http://67-72chevytrucks.com/vboard/s...wheel+bearings I'm not sure if the swap info applies to 3/4 ton, but you may be able to match bearing numbers cheaper than NAPA, as one poster suggests. Here's another good thread: http://67-72chevytrucks.com/vboard/s...wheel+bearings Larry Last edited by fleetsidelarry; 08-15-2009 at 04:48 PM. Reason: added thread



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.