how not to lower your truck! - The 1947 - Present Chevrolet & GMC Truck Message Board Network

glendale · 09-02-2010, 03:14 PM

or check your jackstands. i lived no permant damage.

*blackedoutharley* · 09-02-2010, 03:19 PM

Wtf?

glendale · 09-02-2010, 03:25 PM

when you go to swap the five lug rear make sure you have the e-brake cable disconnected. otherwise you might just try and pull the truck over on your lap...

*blackedoutharley* · 09-02-2010, 03:29 PM

Holy!

Is that what happened?

chevy_mike · 09-02-2010, 03:42 PM

Damn!!! Glad you nor the truck were hurt.

Had a similar thing working on a Baja bug. I was resetting the rear spring plates to lift it. I had the jack chained to the body while I lifted up the spring plate to get it over the stop. The jack basically flipped itself under the load and the spring plate slammed the floor, knocking the whole car off the jack stands. Had my leg been under there, it would not be attached today. There is still a gouge in my parents garage floor.

glendale · 09-02-2010, 03:43 PM

yep!it freaked me out pretty bad.and i am a freak about jackstands. i always check them over pretty good. this time not enough..

jonzcustomshop · 09-02-2010, 05:37 PM

Is that driveway on a little bit of an angle too?
that could play into it.
my driveway slopes down a little, and makes me nervous to jack anything on it, stuff is always trying to move down hill....
glad/lucky you came out ok!

irish1966 · 09-02-2010, 05:44 PM

Quote:

Originally Posted by glendale

yep!it freaked me out pretty bad.and i am a freak about jackstands. i always check them over pretty good. this time not enough..

You are not alone. It happened to me dropping the tank on a camaro, but we managed to stabilize it before it fell. Wasn't a funny split second though. Just about crapped me pants. Wasn't my car either.

geezer#99 · 09-02-2010, 06:15 PM

Heavy duty jackstands are good but I always throw the tires and rims under the frame somewhere too or use my floor jack as a backup under the rearend or front crossmember.

losthope · 09-02-2010, 07:24 PM

you always said you liked when the car was low and the club plauqe scraped on the ground but dang glendale!!

glendale · 09-02-2010, 07:33 PM

Quote:

Originally Posted by losthope

you always said you liked when the car was low and the club plauqe scraped on the ground but dang glendale!!

yea no kidding. i keep looking at the pics thinking it looks sick that low!now get your ass up here and help me finish this pig..

GGinferno · 09-02-2010, 09:26 PM

Who needs air bags! when you can order a glendale lowering kit!

I dont trust jack for sH%T! at least you are still walking!

glendale · 09-02-2010, 10:29 PM

yea it was crazy. super slow motion. i still need to finish it.hey gg you taking your truck to billetproof?

CenValyCali · 09-02-2010, 11:07 PM

I just dropped a 68 on my face Saturday. Fractured my jaw in two places. The Doctor said it wasn't a emergency so I need to wait for surgery

Glad your ok.

Sillyoldman · 09-02-2010, 11:22 PM

I got lucky with four broken ribs, torn cartilage and a dislocated shoulder. Now I usually put a 16" firewood round under anything I'm under. Scary stuff.

shortbed70 · 09-02-2010, 11:35 PM

Glad to see your ok I also have had a vehicle come down on me but I was laying under it on jackstands and front wheels chocked well one of the supports on the stand broke and I moved just enough to not get my head smashed by the rearend.

63rexC10 · 09-03-2010, 12:50 AM

Quote:

Originally Posted by jonzcustomshop

Is that driveway on a little bit of an angle too?
that could play into it.
my driveway slopes down a little, and makes me nervous to jack anything on it, stuff is always trying to move down hill....
glad/lucky you came out ok!

$h!t always rolls downhill. I'm glad you and the truck are

That's definitely one way to lay frame

fryer1979 · 09-03-2010, 02:34 AM

Glad you or the truck wasn't hurt. I've scared the crap out of myself a time or two with some wobbling on the stands. Never fun.

63sbssbbw · 09-03-2010, 06:01 AM

Glad your ok Glendale
My scariest predictament was swapping out a grenaded rear u-joint on the side of the highway on my lowered g body Grand prix with only a bumper jack, the cars whizzing by wasn't too bad,it was the semi trucks that made things move while I was under there.
I think back to that day everytime I jack up a vehicle.
Like others have said,anything you can throw under there as a secondary precaution is a good thing.
Years ago, my Dads neighbor never made it out from under his own ride.
T

**ChiefRocka** · 09-03-2010, 08:35 AM

Glad your ok man ...

Quote:

Originally Posted by chevy_mike

Damn!!! Glad you nor the truck were hurt.

Had a similar thing working on a Baja bug. I was resetting the rear spring plates to lift it. I had the jack chained to the body while I lifted up the spring plate to get it over the stop. The jack basically flipped itself under the load and the spring plate slammed the floor, knocking the whole car off the jack stands. Had my leg been under there, it would not be attached today. There is still a gouge in my parents garage floor.

Good 'ol VW spring plates !!

Never had that problem as a kid, due to the fact mine were turned up like 3 notches !! Although, the Dune-buggy might be a different story !!

09-02-2010, 03:14 PM	#1
glendale Registered User Join Date: Jul 2009 Location: sacramento,ca Posts: 338	how not to lower your truck! or check your jackstands. i lived no permant damage.

09-02-2010, 03:19 PM	#2
blackedoutharley Account Suspended Join Date: Jul 2007 Location: Plumas Lake, Ca. Posts: 1,009	Re: how not to lower your truck! Wtf?

09-02-2010, 03:25 PM	#3
glendale Registered User Join Date: Jul 2009 Location: sacramento,ca Posts: 338	Re: how not to lower your truck! when you go to swap the five lug rear make sure you have the e-brake cable disconnected. otherwise you might just try and pull the truck over on your lap...

09-02-2010, 03:29 PM	#4
blackedoutharley Account Suspended Join Date: Jul 2007 Location: Plumas Lake, Ca. Posts: 1,009	Re: how not to lower your truck! Holy! Is that what happened?

09-02-2010, 03:42 PM	#5
chevy_mike Never Ending Projects Join Date: Jul 2006 Location: San Diego, CA Posts: 3,836	Re: how not to lower your truck! Damn!!! Glad you nor the truck were hurt. Had a similar thing working on a Baja bug. I was resetting the rear spring plates to lift it. I had the jack chained to the body while I lifted up the spring plate to get it over the stop. The jack basically flipped itself under the load and the spring plate slammed the floor, knocking the whole car off the jack stands. Had my leg been under there, it would not be attached today. There is still a gouge in my parents garage floor. __________________ . 1965 C10 Panel, Tiki Express http://www.67-72chevytrucks.com/vboa...d.php?t=506580 SOLD 1968 Chevy C10, Long, Fleetside, Hot Rod Hauler http://67-72chevytrucks.com/vboard/s...d.php?t=313233 SOLD 1965 Chevy C10, Long, Fleetside, Hot Rod C10 http://67-72chevytrucks.com/vboard/s...d.php?t=415702 SOLD We were given two ears and one mouth for a reason... listen twice as much and speak half as often... Last edited by chevy_mike; 09-02-2010 at 03:43 PM.

09-02-2010, 03:43 PM	#6
glendale Registered User Join Date: Jul 2009 Location: sacramento,ca Posts: 338	Re: how not to lower your truck! yep!it freaked me out pretty bad.and i am a freak about jackstands. i always check them over pretty good. this time not enough..

09-02-2010, 05:37 PM	#7
jonzcustomshop 1961 crewcab Join Date: Dec 2007 Location: missoula, mt Posts: 6,164	Re: how not to lower your truck! Is that driveway on a little bit of an angle too? that could play into it. my driveway slopes down a little, and makes me nervous to jack anything on it, stuff is always trying to move down hill.... glad/lucky you came out ok! __________________ 60 build: http://67-72chevytrucks.com/vboard/s...d.php?t=280904 61 crew build: http://67-72chevytrucks.com/vboard/s...d.php?t=646830 63 build: http://67-72chevytrucks.com/vboard/s...d.php?t=336537 64 'burb build: http://67-72chevytrucks.com/vboard/s...d.php?t=448681 65 'burb build: http://67-72chevytrucks.com/vboard/s...d.php?t=590715 65 build: http://67-72chevytrucks.com/vboard/s...d.php?t=281955

09-02-2010, 06:15 PM	#9
geezer#99 Registered User Join Date: Aug 2009 Location: Bowser Posts: 13,733	Re: how not to lower your truck! Heavy duty jackstands are good but I always throw the tires and rims under the frame somewhere too or use my floor jack as a backup under the rearend or front crossmember.

09-02-2010, 07:24 PM	#10
losthope Registered User Join Date: Apr 2010 Location: sacramento ca. Posts: 1,038	Re: how not to lower your truck! you always said you liked when the car was low and the club plauqe scraped on the ground but dang glendale!!

09-02-2010, 09:26 PM	#12
GGinferno DiablosWeldingFabrication Join Date: Jun 2009 Location: Elverta ,CA Posts: 201	Re: how not to lower your truck! Who needs air bags! when you can order a glendale lowering kit! I dont trust jack for sH%T! at least you are still walking! Last edited by GGinferno; 09-02-2010 at 09:55 PM.

09-02-2010, 10:29 PM	#13
glendale Registered User Join Date: Jul 2009 Location: sacramento,ca Posts: 338	Re: how not to lower your truck! yea it was crazy. super slow motion. i still need to finish it.hey gg you taking your truck to billetproof?

09-02-2010, 11:07 PM	#14
CenValyCali Registered User Join Date: Mar 2010 Location: Hanford, Ca Posts: 139	Re: how not to lower your truck! I just dropped a 68 on my face Saturday. Fractured my jaw in two places. The Doctor said it wasn't a emergency so I need to wait for surgery Glad your ok. Last edited by Sillyoldman; 09-02-2010 at 11:16 PM. Reason: Language. Please review our rules.

09-02-2010, 11:22 PM	#15
Sillyoldman #16876 Join Date: Apr 2005 Location: Auburn WA Posts: 12,266	Re: how not to lower your truck! I got lucky with four broken ribs, torn cartilage and a dislocated shoulder. Now I usually put a 16" firewood round under anything I'm under. Scary stuff. __________________ Posted via Stationary Device '71 Custom Deluxe C-20 402. '67 Buick Special 455. '49 Plymouth Special Deluxe. *"I love that old car smell"* *Some people are like Slinkies... not really good for anything, but they still bring a smile to your face when you push them down a flight of stairs.*

09-02-2010, 11:35 PM	#16
shortbed70 Registered User Join Date: Mar 2002 Location: Forney TX Posts: 4,512	Re: how not to lower your truck! Glad to see your ok I also have had a vehicle come down on me but I was laying under it on jackstands and front wheels chocked well one of the supports on the stand broke and I moved just enough to not get my head smashed by the rearend. __________________ Troy 1965 Chevy Bagged,361 sbc,voodoo cam,1.5 full roller rockers,patriot 185cc vortec heads 2.02-1.60,vortec weiand polished intake,demon carb my truckhttp://67-72chevytrucks.com/vboard/s...d.php?t=332884 Big Red Dog build http://67-72chevytrucks.com/vboard/s...d.php?t=572274

09-03-2010, 02:34 AM	#18
fryer1979 Redneck Hillbilly Join Date: Jan 2010 Location: Backwoods Posts: 1,307	Re: how not to lower your truck! Glad you or the truck wasn't hurt. I've scared the crap out of myself a time or two with some wobbling on the stands. Never fun.



Register or Log In To remove these advertisements.

09-03-2010, 06:01 AM	#19
63sbssbbw UCA63 Join Date: Aug 2005 Location: Lloydminster AB Can. Posts: 1,637	Re: how not to lower your truck! Glad your ok Glendale My scariest predictament was swapping out a grenaded rear u-joint on the side of the highway on my lowered g body Grand prix with only a bumper jack, the cars whizzing by wasn't too bad,it was the semi trucks that made things move while I was under there. I think back to that day everytime I jack up a vehicle. Like others have said,anything you can throw under there as a secondary precaution is a good thing. Years ago, my Dads neighbor never made it out from under his own ride. T __________________ member#7816 "63 sb ss bbw 350\350 12 bolt rear Pwr Fr Disc PS tilt '61 GMC in progress '63 GMC to use for parts '90 Chevy Ext cab sbfs 5.7l (current d d)

Register or Log In To remove these advertisements.