|
12-28-2010, 10:52 AM
|
#1 |
|
Registered User
Join Date: Jul 2010
Location: Sikeston MO
Posts: 96
|
Blazer roll bar
I have been trying to find a good factory roll bar for my 72 k5 but the shipping for a complete is normally outrageous are there any aftermarket kits or any of you guys have any plans for a custom roll bar?
Posted via Mobile Device |
|
|
|
12-29-2010, 12:13 PM
|
#2 |
|
Registered User
Join Date: Dec 2010
Location: Pahrump, Nevada
Posts: 451
|
Re: Blazer roll bar
JKmyer84,
I was think the same thing? I have been looking for a factory one for a while? even if I found one the freight would be more than the bar. I was thinking of buying 2" dies for my bender and just make one. I would think some one has made them before and sent them out in a weld it yourself kit? I hope some can replay to this question? Thanks, CORSAIR
__________________
"The Can't Family Lives Across The Street" |
|
|
|
|
12-29-2010, 07:37 PM
|
#3 |
|
Registered User
 Join Date: Jul 2010
Location: mtn.home ar
Posts: 235
|
Re: Blazer roll bar
check out broncobob.com (all4funoffroad) its mostly bronco stuff but about half way down the page it say s they build them for blazers . I got a price some time back for a six point for my 72 seemed like nice people and you could order it welded on in a kit and said they could adjust it any way i needed . Im sure they could duplicate a factory one for you if you had the measurements. Seemed pretty reasonable compared to buying a bender and dies only to use a few times!!!!!! Hope this helps
|
|
|
|
|
12-29-2010, 07:50 PM
|
#4 |
|
Registered User
Join Date: Dec 2010
Location: Pahrump, Nevada
Posts: 451
|
Re: Blazer roll bar
72K-5,
Thanks for the heads up I will check it out. CORSAIR
__________________
"The Can't Family Lives Across The Street" |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
