|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
03-14-2011, 12:29 AM
|
#1 |
|
Registered User
Join Date: Jan 2011
Location: Tulsa, OK
Posts: 32
|
Help with K10 Dimensions
I am trying to design and fab a E-Brake bar for my 1961 K10 4x4. I am missing the bar and springs and cables under the cab and aft to the rear end. The cable attached to the lever under the steering wheel is pulled apart at the hand lever. Can someone with a 61 4x4 measure their bar and the lengths for the armored cables to the rear drums for me? I have started a working drawing for the new bar and need to verify dimensions.
http://i1238.photobucket.com/albums/...-Brake_Bar.jpg
__________________
I like More's Law 'If more is better, then too much is just right.' http://s1238.photobucket.com/albums/...20chevy%20k10/ 1971 Chevelle - sbc 350 TH350 1961 K10 - sbc 400 4 spd M/T short stepside |
|
|
|
03-14-2011, 08:23 AM
|
#2 |
|
Senior Member
Join Date: Aug 2005
Location: Greenwell Springs, Louisiana
Posts: 2,882
|
Re: Help with K10 Dimensions
This would be usefull to me as well, my parking brake pieces have been long gone. Sorry i couldnt help.
|
|
|
|
|
03-15-2011, 03:47 AM
|
#3 |
|
Registered User
Join Date: Jan 2011
Location: Tulsa, OK
Posts: 32
|
Re: Help with K10 Dimensions
Bump . . .Anybody out there with a short wheel base step side 4x4 with the boards out of the bed that can take some dimensions of the e-brake bar? Or cables going to the rear end?
__________________
I like More's Law 'If more is better, then too much is just right.' http://s1238.photobucket.com/albums/...20chevy%20k10/ 1971 Chevelle - sbc 350 TH350 1961 K10 - sbc 400 4 spd M/T short stepside |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
