The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > General Truck Forums > Engine & Drivetrain > LSx Swaps

Web 67-72chevytrucks.com


Reply
 
Thread Tools Display Modes
Old 06-20-2012, 09:55 PM   #1
yossarian19
Registered User
 
Join Date: Sep 2011
Location: Nevada City, CA
Posts: 908
SM420 & a VSS. Been done?

Ok, so for financial reasons I was / am planning to keep the SM420 transmission that is in the truck and bolt it to my 4.8L LS engine.
I had found out which clutch, flywheel & pilot bearing to use and was happily riding my bicycle, almost home and about to pull out my credit card to buy parts, when I thought "Oh, snap. I think I'm going to need a VSS signal and I don't know where to get one"
I called Jagsthatrun.com and they don't know.
I looked at Novak & Advance Adapters & they don't offer VSS kits for transmissions, just transfer cases. I have a 2wd.
So where do I go from here? Suck it up, buy a $600 4L60E transmission, $50 in plumbing & a new (junkyard) column to boot?
Or what else can I do here? Running without VSS, to me, isn't an option.
yossarian19 is offline   Reply With Quote
Old 06-20-2012, 10:36 PM   #2
usmcchevy
Has more rust than truck...
 
usmcchevy's Avatar
 
Join Date: Apr 2005
Location: Ivanhoe, MN
Posts: 2,421
Re: SM420 & a VSS. Been done?

Dakota digital SEN-01-4160 its a pass through Vss so you can still hook your speedo cable up.
__________________
1972 Custom/10 SWB, 4.8/4l80e
Build thread

LSx Swap FAQ index
usmcchevy is offline   Reply With Quote
Old 06-21-2012, 06:57 PM   #3
yossarian19
Registered User
 
Join Date: Sep 2011
Location: Nevada City, CA
Posts: 908
Re: SM420 & a VSS. Been done?

Dakota Digital referred me to JTR, or Jags That Run.
JTR has some good options for mechanical speedometers & VSS installs on 4l60Es as well as some pre-LS SBC options. For an LS engine, it looks like I'm down to a programming delete (which I know nothing about), a 40-tooth reluctor wheel and sensor mounted to my pinion flange on the rear end or drive shaft, and / or a different choice of transmission.
Any other ideas?
yossarian19 is offline   Reply With Quote
Reply

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 10:59 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com