|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
11-27-2012, 09:40 PM
|
#1 |
|
Registered User
Join Date: Jun 2000
Location: Stanton, TX
Posts: 17
|
Suburban body swap questions
I've found a body (shell and doors) to replace my rusted out 82. Am I going to be good lifting at the fire wall and rear, or do I need to support the middle while lifting?
Are there any issues I need to be aware of putting a mid-80's body on an 82 frame? |
|
|
|
11-28-2012, 01:44 PM
|
#2 |
|
Registered User
Join Date: May 2005
Location: evington,va
Posts: 1,205
|
Re: Suburban body swap questions
Support it in middle should have four supports an the body will fit fine on the older chassis
Posted via Mobile Device |
|
|
|
|
11-28-2012, 04:56 PM
|
#3 |
|
Registered User
Join Date: Oct 2010
Location: Central Florida
Posts: 116
|
Re: Suburban body swap questions
I don't understand the reply. I would like to know also. I am about to lift my body off later this winter.
|
|
|
|
|
11-28-2012, 08:32 PM
|
#4 |
|
Special Order
  
Join Date: Nov 2004
Location: Mt Airy, MD
Posts: 85,851
|
Re: Suburban body swap questions
I don't understand,either. Four supports would be two in the front (at the firewall) and two at the rear,right? I can't say from experience,but I think that should be enough. If the center of the body needs to bear weight on supports,where and how do you do that w/o damaging?
A later '80s body on an '82 frame is not a problem
__________________
"BUILDING A BETTER WAY TO SERVE THE USA"......67/72......"The New Breed" GMC '67 C1500 Wideside Super Custom SWB: 327/M22/3.42 posi.........."The '67" (project) GMC '72 K2500 Wideside Sierra Custom Camper: 350/TH350/4.10 Power-Lok..."The '72" (rolling) Tim "Don't call me a redneck. I'm a rough cut country gentleman" R.I.P. ~ East Side Low Life ~ El Jay ~ 72BLUZ ~ Fasteddie69 ~ Ron586 ~ 67ChevyRedneck ~ Grumpy Old Man ~ |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
