LS motor angle questions????

[Hart_Rod]

What part of the motor/transmission are you guys using to determine your motor angle? The back of a head? Transmission output shaft? Thanks in advance.

r

[PBFAB.COM]

Originally Posted by Hart_Rod

What part of the motor/transmission are you guys using to determine your motor angle? The back of a head? Transmission output shaft? Thanks in advance.

r

You want to use the face of the output shaft of the trans where the seal goes.

Nate

[Hart_Rod]

Originally Posted by Porterbuilt Street Rods

You want to use the face of the output shaft of the trans where the seal goes.

Nate

Thanks Nate. I thought I had read that, but I wanted to make sure before I drilled any holes. What's the max and min angle when setting this?

[PBFAB.COM]

Originally Posted by Hart_Rod

Thanks Nate. I thought I had read that, but I wanted to make sure before I drilled any holes. What's the max and min angle when setting this?

3 is pretty ideal, and don't go past 6.
Posted via Mobile Device

[Hart_Rod]

Originally Posted by Porterbuilt Street Rods

3 is pretty ideal, and don't go past 6.
Posted via Mobile Device

Cool. Forgot to mention, I will be running a 2 piece driveshaft.

[Hart_Rod]

Nate do you have any pictures or part number of the carrier bearing I should run with the 2-piece drive shaft? TIA