|
12-01-2003, 01:59 AM
|
#1 |
|
Registered User
Join Date: Dec 2003
Location: BC
Posts: 1
|
rear end
Iam in the process of dropping a v8 into a 1969 c20 that had a 292. If I put the engine in the back of the engine bay do I need a longer driveshaft? If I use the V8 motor mount holes at the front can I use the driveshaft out of a 69 c10 with a conversion u-joint?
What is easier as this is not a show truck. |
|
|
|
12-01-2003, 02:16 AM
|
#2 |
|
Registered User
Join Date: Apr 2003
Location: missouri city, tx
Posts: 4,486
|
probably putting the v8 in the v8 spot and using the 69 c10 drive shaft made for a v8
by the way. welcome to the board. i really dont know much about that but welcome! other people who have donethismight know
__________________
70 longbed 496/th400/Ford 9" |
|
|
|
|
12-01-2003, 08:12 AM
|
#3 |
|
Designated A-hole!
Join Date: Mar 2003
Location: South Mississippi
Posts: 36,448
|
Welcome to the board from South Mississippi.
ttt for you.
__________________
"If it ain't broke, fix it 'til it is!" Being stupid ain't illegal.  We're Still Debt Free Except for the House!!! www.daveramsey.com 70 GMC SWB Stepside project "Green Booger" soon to be 6.0l/4l80e 93 S-10 "Poppaw's Truck" |
|
|
|
|
12-01-2003, 09:42 AM
|
#4 |
|
Registered User
Join Date: Dec 1999
Location: Austin, TX, USA
Posts: 7,734
|
I'd put the V8 on the 6 cylinder mounts. This will leave trans and driveshaft in same spot they are in now. If you go to the C10 driveshaft and move the motor, because of the larger rear end of the C20 , most likely the C10 shaft will be too long.
__________________
44 Willys MB 52 M38A1 64 Corvette Coupe 68 Camaro 'vert LT1 & TH700 69 Z/28 355 12.6's @110 69 Chevy Short Step 4 1/2"/7" drop 72 Jimmy 4WD 4spd 4" & 35's 02 GMC 2500HD 4x4 Duramax |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
