The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > 47 - Current classic GM Trucks > The 1973 - 1987 Chevrolet & GMC Squarebody Pickups Message Board > The 1973 - 1991 Blazers, Jimmys, and Suburbans Message Board

Web 67-72chevytrucks.com


Reply
 
Thread Tools Display Modes
Old 10-09-2013, 02:58 AM   #1
Devillusion
Registered User
 
Devillusion's Avatar
 
Join Date: Jan 2010
Location: Brandon, Manitoba, Canada
Posts: 782
Project: Tombstone (81 K5/2WD)

Well....lets see where this one goes.

Saved this one from a huge graveyard locally as it was in a light accident in the front and tweaked the front of the frame slightly and insurance wrote it off. Easy fix, minimal damage....Traded a bunch of left over parts and carcasses for it....good deal in my books.

Plan is to fix it up eventually for the wife (and me ) and just keep things simple on this one at this point.

Will be fixing obviously the rust on the rear quarters, very back ledge of the cargo area floor, inner/outer rockers, and of course doors. For this area this thing is in great shape. Just stripped out the interior to give it a good wash and let it dry out before going into storage for a short bit till the crew is done.

Pulled out the seats, panels, carpet, console etc tonight and discovered minimal to no rust on the floor area, and a bit across the back of the cargo/gate area. Pulled off the factory plastic on the floors and was near brand new steel underneath. Very happy!!!!

This won't be a speedy thread by any means....but will keep updated as progress continues.




__________________
1967 K30 4x4/12v Cummins/getrag/D60/D70/355s
1967 GMC suburban 4x4/LS swap 5.3/4500/205/10 bolt/14 bolt full floater
1963 C10 reg cab long box
1970 Chevelle
1968 Biscayne 2dr post


"...there is no excuse for what I am about to do, but dangit....it's gonna be fun!"
Devillusion is offline   Reply With Quote
Old 10-09-2013, 03:03 AM   #2
Devillusion
Registered User
 
Devillusion's Avatar
 
Join Date: Jan 2010
Location: Brandon, Manitoba, Canada
Posts: 782
Re: Project: Tombstone (81 K5/2WD)






Just for kicks I was curious what the original paint would polish up like....who says you can't polish a turd? lmao...actually comes out pretty decent after around 30 seconds or so....not much effort that is for sure.

__________________
1967 K30 4x4/12v Cummins/getrag/D60/D70/355s
1967 GMC suburban 4x4/LS swap 5.3/4500/205/10 bolt/14 bolt full floater
1963 C10 reg cab long box
1970 Chevelle
1968 Biscayne 2dr post


"...there is no excuse for what I am about to do, but dangit....it's gonna be fun!"
Devillusion is offline   Reply With Quote
Old 10-11-2013, 10:11 AM   #3
Low Elco
Registered User
 
Join Date: Apr 2003
Location: Indep, MO
Posts: 5,893
Re: Project: Tombstone (81 K5/2WD)

Holy Schnikies, that's a 2X! Nice Score!
Low Elco is offline   Reply With Quote
Old 10-11-2013, 10:25 AM   #4
68Timber
I know the pieces fit
 
68Timber's Avatar
 
Join Date: Nov 2007
Location: MONTGOMERY, AL
Posts: 5,523
Re: Project: Tombstone (81 K5/2WD)

I'm in.
__________________
John

79 2wd Blazer (Bruiser)
85 M1009 Blazer (Sarge) build
74 Honda Z50 build
68Timber is offline   Reply With Quote
Old 10-11-2013, 09:44 PM   #5
1984 t type
Registered User
 
Join Date: Nov 2010
Location: MICHIGAN
Posts: 196
Re: Project: Tombstone (81 K5/2WD)

Gotta love those seats
__________________
1987 Buick Grand National
2018 Road Glide Special
1984 t type is offline   Reply With Quote
Old 10-11-2013, 09:49 PM   #6
gclark1
Registered User
 
gclark1's Avatar
 
Join Date: Jan 2013
Location: Mesa, AZ
Posts: 161
Re: Project: Tombstone (81 K5/2WD)

Going to be a lot of work, but oh so much fun!
gclark1 is offline   Reply With Quote
Old 10-12-2013, 02:25 AM   #7
Devillusion
Registered User
 
Devillusion's Avatar
 
Join Date: Jan 2010
Location: Brandon, Manitoba, Canada
Posts: 782
Re: Project: Tombstone (81 K5/2WD)

Nowhere near as much work as my last K5 was....I had to rebuild everything by hand.

This one ain't bad for around here...even harder finding the 2wd. Guy had no interest in it cause it was a 2 wheeler..."I'll take it" I said...lmao.

Gathering up all the parts under the hood that were removed as someone started to strip off stuff....found out it has a fresh rebuild under the hood as well as brand new starter, fuel pump, and alternator along with all the other accessories. Hoping it still runs good as it has been sitting for 2 years now since it was crashed and parked. Should be able to have her running in the next week or so under her own power. Then get parked out back for the winter months till the crew is more underway....Removed all the crap the last owner had mounted to the underdash, back deck, and trailer brake assembly and wiring. Just cleaned it all up so it is back to it's original unmolested state now. As I said, going to keep things fairly simple on this....Even located the matching rear seat out of the truck...guy just wants another one on trade to be able to get it.

Here are some pics after she was all washed up and stripped out.....I put everything back in minus carpet and underlay so that she stays dry and cut back on any further rot while awaiting her fate.

Also cut out the bad rust areas on the sheetmetal to keep it somewhat at bay as well. Going to be doing full quarters, but wanted to preserve as much of the inner sections as possible. Will spray her down top to bottom with penetrating oil before storage to make life easier later on and hold back the cancer as much as possible.





__________________
1967 K30 4x4/12v Cummins/getrag/D60/D70/355s
1967 GMC suburban 4x4/LS swap 5.3/4500/205/10 bolt/14 bolt full floater
1963 C10 reg cab long box
1970 Chevelle
1968 Biscayne 2dr post


"...there is no excuse for what I am about to do, but dangit....it's gonna be fun!"
Devillusion is offline   Reply With Quote
Old 10-12-2013, 08:22 AM   #8
68Timber
I know the pieces fit
 
68Timber's Avatar
 
Join Date: Nov 2007
Location: MONTGOMERY, AL
Posts: 5,523
Re: Project: Tombstone (81 K5/2WD)

Neat to see an original Silverado truck without AC. Don't see stuff like that here in AL.
__________________
John

79 2wd Blazer (Bruiser)
85 M1009 Blazer (Sarge) build
74 Honda Z50 build
68Timber is offline   Reply With Quote
Old 10-12-2013, 10:16 AM   #9
Devillusion
Registered User
 
Devillusion's Avatar
 
Join Date: Jan 2010
Location: Brandon, Manitoba, Canada
Posts: 782
Re: Project: Tombstone (81 K5/2WD)

Ya, around here there are lots with no ac options on the older trucks. No need for it 7 months out of the year hahahaha
__________________
1967 K30 4x4/12v Cummins/getrag/D60/D70/355s
1967 GMC suburban 4x4/LS swap 5.3/4500/205/10 bolt/14 bolt full floater
1963 C10 reg cab long box
1970 Chevelle
1968 Biscayne 2dr post


"...there is no excuse for what I am about to do, but dangit....it's gonna be fun!"
Devillusion is offline   Reply With Quote
Old 10-13-2013, 12:39 PM   #10
68Timber
I know the pieces fit
 
68Timber's Avatar
 
Join Date: Nov 2007
Location: MONTGOMERY, AL
Posts: 5,523
Re: Project: Tombstone (81 K5/2WD)

What is the small badge under the K5 fender emblems? ESC?
__________________
John

79 2wd Blazer (Bruiser)
85 M1009 Blazer (Sarge) build
74 Honda Z50 build
68Timber is offline   Reply With Quote
Old 10-13-2013, 01:17 PM   #11
Devillusion
Registered User
 
Devillusion's Avatar
 
Join Date: Jan 2010
Location: Brandon, Manitoba, Canada
Posts: 782
Re: Project: Tombstone (81 K5/2WD)

Yes, I believe so.

That will be eliminated and tossed....lol
__________________
1967 K30 4x4/12v Cummins/getrag/D60/D70/355s
1967 GMC suburban 4x4/LS swap 5.3/4500/205/10 bolt/14 bolt full floater
1963 C10 reg cab long box
1970 Chevelle
1968 Biscayne 2dr post


"...there is no excuse for what I am about to do, but dangit....it's gonna be fun!"
Devillusion is offline   Reply With Quote
Reply

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 12:50 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com