![]() |
![]() |
#1 |
Registered User
![]() Join Date: Nov 2013
Location: Roseville, CA
Posts: 207
|
Tail lights
When I bought my truck The PO had installed 4 " truck lights in the fenders. One of the lens was faded, So I wanted to change them out. With 4" holes I was Limted Went to O'reilly's & found 4" LED lights. Had to enlarge the holes to 4 1/2, came with rubber ring grommet. Had to cut the face of the grommet off
& put on the stainless trim rings that I got off ebay. Now the are flush mount. The old lights had a rubber ring around the light about 3/8 thick as you can see by the picture. |
![]() |
![]() |
![]() |
#2 |
Senior Member
![]() Join Date: Dec 2013
Location: Gods country East,Tn
Posts: 8,545
|
Re: Tail lights
Looks clean !
|
![]() |
![]() |
![]() |
#3 |
Rusty Nuts
Join Date: Sep 2008
Location: Clever Missouri
Posts: 1,338
|
Re: Tail lights
Looks pretty good. How do they look turned on, I bet they are bright.
__________________
(Clever Missouri) Southwest Larry Mr Chevrolet My Build, The Marathon Truck http://67-72chevytrucks.com/vboard/s...d.php?t=604414 |
![]() |
![]() |
![]() |
#4 |
Senior Member
![]() Join Date: Mar 2012
Location: Chesapeake, Va
Posts: 1,275
|
Re: Tail lights
what is your plan with the cargo light hole?
__________________
Mike 72 C-10 Cheyenne off frame resto and Upgraded to 4 wheel disk, Tilt, Dakota Digital Dash / Rear slider. 421 SBC / TH350 3000RPM Stall Progression Ignition /Holley 750 DP/3:73 gear Eaton Limited Slip unit / 2 1/2 exhaust glasspacks ![]() |
![]() |
![]() |
![]() |
#5 |
Registered User
![]() Join Date: Nov 2013
Location: Roseville, CA
Posts: 207
|
Re: Tail lights
Looking at LED's on ebay, Lots to choose from. Going to find a bad/used cargo light to modify. 1st picture running lights, 2nd stop light. They are nice & bright.
|
![]() |
![]() |
![]() |
Bookmarks |
|
|