Tunnel mods for 6L80E or 6L90E?

[codeJbird]

Originally Posted by eric8

Did you use motor mount plates that keep the engine in the stock location?

It is close to stock location. I kept the mounts that came with the motor and fitted them to frame.

[codeJbird]

Originally Posted by Hart_Rod

Here are a few pictures of the high hump mod. You can also lookin in my 68 build thread to find more.

This is exactly how i did mine and it fit just the same.

[eric8]

Sorry, I'm a little slow. So the low hump is welded in from the factory and you have to cut it out? But the high humps were bolted in? I seem to recall the factory assembly manual showing both humps being bolt in, but I could be mistaken.

So in order to make a factory carpet mat work, I'd need to order carpet for a big block or 4wd model?

[hugger6933]

All low humps are made in the floor. All high humps are bolted in. You can mod a low hump to a high one by cutting out the hump and bolting the high one in. Yes the carpet offered is stated low hump or high hump in most places. I hope this helps clear up a bit for you. Jim

[eric8]

Gotcha...makes sense and sounds like a mod that I could actually handle doing.