|
02-23-2014, 02:29 PM
|
#1 |
|
Registered User
Join Date: Jun 2004
Location: GRAFTON , OHIO
Posts: 58
|
57 Forward Tilt Hood
Looking for a forward tilt hood kit. 1957 Chevy Truck.
Who has the best fit and finish kits? That work good ? anything good or Bad would help. Thanks |
|
|
|
02-23-2014, 02:33 PM
|
#2 |
|
Registered User
Join Date: Aug 2010
Location: Melville Saskatchewan
Posts: 99
|
Re: 57 Forward Tilt Hood
No Limit. Seen the kits but I can't speak to their quality. Looked good.
|
|
|
|
|
02-23-2014, 02:50 PM
|
#3 |
|
Registered User
 
Join Date: Jul 2007
Location: Toppenish, WA
Posts: 15,711
|
Re: 57 Forward Tilt Hood
I don't think that you would have any issues with the No Limit kit. They don't like to sell anything they come up with until they have all the bugs worked out.
__________________
Founding member of the too many projects, too little time and money club. My ongoing truck projects: 48 Chev 3100 that will run a 292 Six. 71 GMC 2500 that is getting a Cad 500 transplant. 77 C 30 dualie, 454, 4 speed with a 10 foot flatbed and hoist. It does the heavy work and hauls the projects around. |
|
|
|
|
02-24-2014, 07:20 PM
|
#4 |
|
big guy
Join Date: Jun 2008
Location: mass
Posts: 824
|
Re: 57 Forward Tilt Hood
I got mine from no limit and had to do a little work to it to get it right, Still a nice kit for the money.
Ray |
|
|
|
|
02-26-2014, 03:28 AM
|
#5 | |
|
Senior Member
  
Join Date: Nov 2008
Location: Glendora, CA
Posts: 6,344
|
Re: 57 Forward Tilt Hood
Quote:
__________________
'55 Big Window Shortbed, Drive-It-&-Work-On-It slid down the "slippery slope" to a Frame-Off Rodstoration! LQ4/4l85e/C4 IFS/Mustang 8.8 rearend w/3.73's Dan's '55 Big Window "Build" - Well, Kinda! |
|
|
|
|
|
02-26-2014, 07:33 AM
|
#6 |
|
big guy
Join Date: Jun 2008
Location: mass
Posts: 824
|
Re: 57 Forward Tilt Hood
Dan when i get home from work i will send you some pic's of what i had to do.
Ray |
|
|
|
|
02-26-2014, 07:49 PM
|
#7 |
|
big guy
Join Date: Jun 2008
Location: mass
Posts: 824
|
Re: 57 Forward Tilt Hood
As you can see they didn't sit flat the angle was off so, i used a die grinder and cut right where the bend was about a 1/8" deep or just till i could bend it to sit flat and then re welded it together. Everything else was fine, not a big deal.
Ray |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
