brake assembly from 98-02 camaro ls1on a 64

[jadedbird]

So I plan on running a lsx/t56. And I might be buying adonor camaro. Is there a way to run the discs on all four corners? I know for the rears cptn fab sells a bracket, but what about the front? Also I wouldn't mind running 5x4.75 bolt pattern. And I know I'll need the rear shafts will have to be redrilled

[chevy_mike]

If you use the CPP 2" drop Modular spindles, these are setup to use a bolt on brake mounting bracket. This should allow you to use the front calipers but not the rotors. Should be fairly bolt on.

[jadedbird]

What rotor would I used then? And would I utilize the brake booster from the camaro?

[61K10]

there is something about using an le1 camaro rotor

[Captainfab]

That depends on how much fabricating you want to do. For starters, the '98-'02 F-body wheel stud pattern is 5 x 4.65" not 5 x 4.75". The front rotors are separate from the hubs, so you would have to either buy the aftermarket aluminum hubs or figure out a cheaper alternative

I don't know if the '98-'02 booster fits my booster brackets or not. I do not know the stud mounting pattern.

Originally Posted by jadedbird

What rotor would I used then? And would I utilize the brake booster from the camaro?

Yes that is correct for the front rotors. I will see if I can find that thread with the specifics.

Edit: here is the link to that thread.

http://www.67-72chevytrucks.com/vboa...d.php?t=319487

Originally Posted by 61K10

there is something about using an le1 camaro rotor