66 Cab Floor repair parts list - need help

[msg]

I was going to place an order soon for repair panels buy and before I did thought I'd ask you guys whats the usual order for a floor like this







I had years ago bought these floor panels thinking that one day I would fix it. Then as I looked closer the floor pan it doesnt seem to extend far enough to repair the holes that are where the floor angles up under your feet. Is there a panel to repair that portion or just find some scrap metal and cut to fit?



I also bought a cab corner and rocker panels. The 2 other metal parts were in the photo but are just moving box braces for hanging clothes on.


Besides what parts I have, what other parts will I need to get the job done you think?

I was on top bananas site and this part seemed like what I need

http://www.topbananaparts.com/driver...r-section.html

and maybe these
http://www.topbananaparts.com/driver...ot-well-1.html

I am planning to get the cab sandblasted in a few weeks and wasnt sure also if I should go ahead and cut out some areas so the blaster can get to more of the rust. Any pointers on that would be appreciated.

[1963c-10]

You'll probably need outer rockers as well. And check under the truck.....if the floor looks like that the cab supports may be due to be replaced.

[Lokin4AReason]

just make sure you look over everything twice .. because if its me, I just dislike waiting for part(s) at when its going together

esp. the support(s) ( as mentioned already )

[Nsanehotrodz]

Originally Posted by msg

I was going to place an order soon for repair panels buy and before I did thought I'd ask you guys whats the usual order for a floor like this







I had years ago bought these floor panels thinking that one day I would fix it. Then as I looked closer the floor pan it doesnt seem to extend far enough to repair the holes that are where the floor angles up under your feet. Is there a panel to repair that portion or just find some scrap metal and cut to fit?



I also bought a cab corner and rocker panels. The 2 other metal parts were in the photo but are just moving box braces for hanging clothes on.


Besides what parts I have, what other parts will I need to get the job done you think?

I was on top bananas site and this part seemed like what I need

http://www.topbananaparts.com/driver...r-section.html

and maybe these
http://www.topbananaparts.com/driver...ot-well-1.html

I am planning to get the cab sandblasted in a few weeks and wasnt sure also if I should go ahead and cut out some areas so the blaster can get to more of the rust. Any pointers on that would be appreciated.

I would wait until you get it sandblasted and see exactly what you need. This will save you $$ shipping.