|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
06-27-2016, 05:58 PM
|
#1 |
|
Registered User
 Join Date: Feb 2016
Location: Valrico, Florida
Posts: 661
|
66 c10 lower ball joint seal
Stupid question. Does ball joint seal get pressed on at same tim from bottom or get pressed on from top after ball joint on?
|
|
|
|
06-27-2016, 11:13 PM
|
#2 |
|
Registered User
Join Date: Jan 2013
Location: Imperial, MO
Posts: 1,003
|
Re: 66 c10 lower ball joint seal
It goes on from the top after the balljoint has been pressed into the arm.
|
|
|
|
|
06-28-2016, 07:50 AM
|
#3 |
|
Registered User
Join Date: Feb 2016
Location: Valrico, Florida
Posts: 661
|
Re: 66 c10 lower ball joint seal
oh good. i thought so. does the spindle hold it in place? wasnt sure how far on the ball joint that the dust boot sits on.
|
|
|
|
|
06-28-2016, 10:58 AM
|
#4 |
|
Registered User
Join Date: Jan 2013
Location: Imperial, MO
Posts: 1,003
|
Re: 66 c10 lower ball joint seal
Once the spindle is installed the boot won't be able to fall off of course, but it should be well seated at the base. Some of the cheaper balljoints/boots don't fit together too well.
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
