The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > 47 - Current classic GM Trucks > The 1973 - 1987 Chevrolet & GMC Squarebody Pickups Message Board

Web 67-72chevytrucks.com


Reply
 
Thread Tools Display Modes
Old 07-20-2016, 11:12 PM   #1
cjthompson
Registered User
 
Join Date: Jan 2016
Location: Bowling Green, Ky
Posts: 40
Dash lights

Anyone know a good supplier or have recommendations on what bulbs to use? Mine are pretty burnt out.
cjthompson is offline   Reply With Quote
Old 07-20-2016, 11:20 PM   #2
E.D.75GMC
Registered User
 
E.D.75GMC's Avatar
 
Join Date: Aug 2013
Location: Calgary Alberta
Posts: 273
Re: Dash lights

The bulbs are 194/168 any parts store will have them. If I were you though I would buy the 194 LEDs as they make a huge difference over stock and put less drain on the battery when you come to a stop.
Attached Images
 
E.D.75GMC is offline   Reply With Quote
Old 07-20-2016, 11:22 PM   #3
cjthompson
Registered User
 
Join Date: Jan 2016
Location: Bowling Green, Ky
Posts: 40
Re: Dash lights

Awesome! Do you happen to know quantities of each?
cjthompson is offline   Reply With Quote
Old 07-20-2016, 11:36 PM   #4
chengny
Registered User
 
chengny's Avatar
 
Join Date: May 2007
Location: New Hampshire
Posts: 349
Re: Dash lights

You have 5 lamps for cluster backlighting and an other one - for HVAC control panel illumination - that is on the same circuit.
chengny is offline   Reply With Quote
Old 07-21-2016, 01:40 AM   #5
E.D.75GMC
Registered User
 
E.D.75GMC's Avatar
 
Join Date: Aug 2013
Location: Calgary Alberta
Posts: 273
Re: Dash lights

My 75 with no A/C used a different, smaller, bulb in the HVAC. Not sure what # it is though.
E.D.75GMC is offline   Reply With Quote
Old 07-21-2016, 01:41 AM   #6
E.D.75GMC
Registered User
 
E.D.75GMC's Avatar
 
Join Date: Aug 2013
Location: Calgary Alberta
Posts: 273
Re: Dash lights

Also, the LEDs are polarized so if some don't work just flip the bulb around 180 degrees.
E.D.75GMC is offline   Reply With Quote
Old 07-21-2016, 02:24 AM   #7
RUN GMC
Registered User
 
RUN GMC's Avatar
 
Join Date: May 2014
Location: North AL
Posts: 363
Re: Dash lights

Quote:
Originally Posted by E.D.75GMC View Post
Also, the LEDs are polarized so if some don't work just flip the bulb around 180 degrees.
^this......after changing out each one turn on dash lights to see if led will light up....if not do what he said........
RUN GMC is offline   Reply With Quote
Old 07-21-2016, 11:57 AM   #8
TKCR
Senior Member
 
TKCR's Avatar
 
Join Date: Oct 2014
Location: Ohio
Posts: 6,979
Re: Dash lights

I also used led bulbs when I replaced all the bulbs in the cluster. It lights up nice at night. Also added led's under the dash.
Attached Images
  
TKCR is offline   Reply With Quote
Old 08-22-2016, 03:22 PM   #9
LDO
Registered User
 
LDO's Avatar
 
Join Date: Feb 2011
Location: Senatobia, MS
Posts: 1,298
Re: Dash lights

Do you recall what PN led bulb goes under the dash? I believe the guage ones are 194s right?
LDO is offline   Reply With Quote
Old 08-22-2016, 03:37 PM   #10
TKCR
Senior Member
 
TKCR's Avatar
 
Join Date: Oct 2014
Location: Ohio
Posts: 6,979
Re: Dash lights

Quote:
Originally Posted by LDO View Post
Do you recall what PN led bulb goes under the dash? I believe the guage ones are 194s right?
1142 is the stock bulb. You can get LED's from any auto store. I added a set of courtesy lights from LMC. That gave me 3 lights under the dash.

http://www.lmctruck.com/icatalog/cc/full.aspx?Page=191

And yes, the 194 are the gauge bulbs.
TKCR is offline   Reply With Quote
Old 08-22-2016, 03:40 PM   #11
LDO
Registered User
 
LDO's Avatar
 
Join Date: Feb 2011
Location: Senatobia, MS
Posts: 1,298
Re: Dash lights

i purchased the same set of courtesy lights (harness) that comes with 2 bulbs. Was going to install LEDs in there to see how it looks.

Thanks!
LDO is offline   Reply With Quote
Old 08-23-2016, 03:11 AM   #12
Danmcg
Registered User
 
Join Date: Jun 2014
Location: Central NY
Posts: 168
Re: Dash lights

Do the led's work with the dimmer switch?
Danmcg is offline   Reply With Quote
Old 08-23-2016, 09:58 AM   #13
CSHADES
Registered User
 
CSHADES's Avatar
 
Join Date: Nov 2015
Location: portage wi
Posts: 506
Re: Dash lights

Quote:
Originally Posted by Danmcg View Post
Do the led's work with the dimmer switch?
Not without the correct dimmer for leds
CSHADES is offline   Reply With Quote
Old 08-24-2016, 03:53 PM   #14
TKCR
Senior Member
 
TKCR's Avatar
 
Join Date: Oct 2014
Location: Ohio
Posts: 6,979
Re: Dash lights

Quote:
Originally Posted by LDO View Post
i purchased the same set of courtesy lights (harness) that comes with 2 bulbs. Was going to install LEDs in there to see how it looks.

Thanks!
The GM spec book calls for 1003 bulb, I looked it up to make sure this time. This is the led bulb I'm using
Posted via Mobile Device
Attached Images
 
TKCR is offline   Reply With Quote
Old 08-24-2016, 03:55 PM   #15
TKCR
Senior Member
 
TKCR's Avatar
 
Join Date: Oct 2014
Location: Ohio
Posts: 6,979
Re: Dash lights

Here's that spec sheet I was talking about for all the bulbs. Hope this helps for any bulb reference you might need.
Posted via Mobile Device
Attached Images
 
TKCR is offline   Reply With Quote
Old 08-24-2016, 04:05 PM   #16
MikeB
Senior Member
 
MikeB's Avatar
 
Join Date: Jul 2000
Location: North Texas
Posts: 3,597
Re: Dash lights

Just be careful of cheapie LED bulbs. I'd go with Philips or Sylvania/Osram, because they are brighter and last longer than eBay specials. If you shop around you can save some money on a 2-pack.
__________________
Mike
1969 C10 LWB -- owned for 35 years. 350/TH350, 3.08 posi, 1st Gen Vintage Air, recent AAW wiring harness, 5-lug conversion, 1985 spindles and brakes.
1982 C10 SWB -- sold
1981 C10 Silverado LWB -- sold, but wish I still had it!
1969 C10 (not the current one) that I bought in the early 1980s. Paid $1200; sold for $1500 a few years later. Just a hint at the appreciation that was coming.
Retired as a factory automation products salesman.
Worked part-time over the years for an engine builder and a classic car repair shop.
Member here for 24 years! This is the very first car/truck Internet forum I joined. I still used a dial-up modem back then!
MikeB is offline   Reply With Quote
Old 08-24-2016, 04:23 PM   #17
TKCR
Senior Member
 
TKCR's Avatar
 
Join Date: Oct 2014
Location: Ohio
Posts: 6,979
Re: Dash lights

Quote:
Originally Posted by MikeB View Post
Just be careful of cheapie LED bulbs. I'd go with Philips or Sylvania/Osram, because they are brighter and last longer than eBay specials. If you shop around you can save some money on a 2-pack.
Your right. I got mine in a 2 pack. I can't remember the brand name, but I have gotten several from superbrightleds.com. These particular bulbs I got from the local auto store, in a 2'pack.
Posted via Mobile Device
TKCR is offline   Reply With Quote
Old 08-24-2016, 04:24 PM   #18
LDO
Registered User
 
LDO's Avatar
 
Join Date: Feb 2011
Location: Senatobia, MS
Posts: 1,298
Re: Dash lights

awesome,
thanks for that!!
LDO is offline   Reply With Quote
Old 08-24-2016, 06:26 PM   #19
Marshy
Registered User
 
Join Date: Nov 2012
Location: Mexico, NY
Posts: 559
Re: Dash lights

What does a pack of 2 cost anyways?
__________________
'84 K10, SM465, NP208, 3.42 Gears, 33x12.5-15
GM 4 bolt 880 roller block, 062 Vortec Heads
Comp Cams XR258HR-10, MSD Street Fighter HEI
Edelbrock: Performer Intake 2116, 1405 Carb
Long tube headers, 2.5" duals to Flow Master Super 40's
Vortec Engine Build
Marshy is offline   Reply With Quote
Old 08-25-2016, 10:50 AM   #20
TKCR
Senior Member
 
TKCR's Avatar
 
Join Date: Oct 2014
Location: Ohio
Posts: 6,979
Re: Dash lights

Quote:
Originally Posted by Marshy View Post
What does a pack of 2 cost anyways?
Around $25
TKCR is offline   Reply With Quote
Old 08-25-2016, 11:17 AM   #21
Marshy
Registered User
 
Join Date: Nov 2012
Location: Mexico, NY
Posts: 559
Re: Dash lights

Thanks.
Had anyone sourced a LED dimmer?
__________________
'84 K10, SM465, NP208, 3.42 Gears, 33x12.5-15
GM 4 bolt 880 roller block, 062 Vortec Heads
Comp Cams XR258HR-10, MSD Street Fighter HEI
Edelbrock: Performer Intake 2116, 1405 Carb
Long tube headers, 2.5" duals to Flow Master Super 40's
Vortec Engine Build
Marshy is offline   Reply With Quote
Old 08-25-2016, 09:44 PM   #22
NorCalAnthony
Registered User
 
Join Date: Jul 2014
Location: Lincoln, CA
Posts: 208
Re: Dash lights

Quote:
Originally Posted by TKCR View Post
Around $25
Or $12.59 through Amazon with Prime shipping avaliable
https://www.amazon.com/gp/aw/d/B017V...ob_neva_mobile
NorCalAnthony is offline   Reply With Quote
Old 08-25-2016, 11:34 PM   #23
TKCR
Senior Member
 
TKCR's Avatar
 
Join Date: Oct 2014
Location: Ohio
Posts: 6,979
Re: Dash lights

Quote:
Originally Posted by NorCalAnthony View Post
Or $12.59 through Amazon with Prime shipping avaliable
https://www.amazon.com/gp/aw/d/B017V...ob_neva_mobile
I was referring to the courtesy lights under the dash
Posted via Mobile Device
TKCR is offline   Reply With Quote
Old 08-26-2016, 10:51 AM   #24
LDO
Registered User
 
LDO's Avatar
 
Join Date: Feb 2011
Location: Senatobia, MS
Posts: 1,298
Re: Dash lights

maybe a little off topic but how are you guys/gals getting lenses (the clear part) so clean?

I've seen some of your dash cluster pics and they look amazing!
LDO is offline   Reply With Quote
Old 08-26-2016, 11:26 AM   #25
TKCR
Senior Member
 
TKCR's Avatar
 
Join Date: Oct 2014
Location: Ohio
Posts: 6,979
Re: Dash lights

Quote:
Originally Posted by LDO View Post
maybe a little off topic but how are you guys/gals getting lenses (the clear part) so clean?

I've seen some of your dash cluster pics and they look amazing!
Myself, I got a new one. I added a clock to my cluster, so I had to get a new one. If you have a clock, the lens needs the little hole for the stem to come thru.

LMC has them. They are not to expensive, but so worth every penny, when you can actually see clearly.


http://www.lmctruck.com/icatalog/cc/full.aspx?Page=76
TKCR is offline   Reply With Quote
Reply

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 10:58 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com