front brakes: 1" vs 1.25"

[UKNOWME]

Originally Posted by Sinisterv10

Well i picked up some bearings from the parts store and apparently i have the spindles that go with the 1.25" rotors so the camaro rotor swap is out unless i get aftermarket lowering spindles or stock 1" spindles. Since the truck is not a DD im having the rotors drilled for now while decide. Thanks for the info.

Sounds like you're already going the easiest and most cost efficient route.

[Sinisterv10]

Originally Posted by UKNOWME

Sounds like you're already going the easiest and most cost efficient route.

Found me some rotors with literally no wear but had them turned just to make sure i start fresh. Got new bearings then had them re drilled. The drilling was done with a CNC machine and the quality is very good. I thought the holes were kinda close to each other for my liking but i liked the fact that the support lugs on the back remained intact. here is a picture of the front and back.