|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
06-27-2018, 08:20 PM
|
#1 |
|
Registered User
Join Date: Jan 2011
Location: Scottsdale, AZ
Posts: 40
|
1957 Bellhousing crossmember
A recent post stated that the bellhousing crossmember is required to maintain the rear cab mount integrity. It was also mentioned the front spring mount is attached to this member. I was going to remove this crossmember to allow more clearance for my 700r transmission but i am rethinking that. Can this crossmember be removed by cuttng the rivits and installing bolts? Can this member be trimmed and then boxed? Please share your experiences. Thanks.
|
|
|
|
06-27-2018, 09:30 PM
|
#2 | |
|
Registered User
 Join Date: Oct 2011
Location: Tucson, AZ
Posts: 639
|
Re: 1957 Bellhousing crossmember
Quote:
|
|
|
|
|
|
06-28-2018, 01:13 AM
|
#3 |
|
Registered User
Join Date: Nov 2010
Location: calgary alberta
Posts: 8,490
|
Re: 1957 Bellhousing crossmember
when I removed mine for a frame boxing exercise I had to cut it to get it out. removing the rivets wasn't enough. not enough room to get it outta there. 57 gmc.
|
|
|
|
|
06-28-2018, 01:57 PM
|
#4 | |
|
Registered User
Join Date: Oct 2011
Location: Tucson, AZ
Posts: 639
|
Re: 1957 Bellhousing crossmember
Quote:
|
|
|
|
|
|
06-28-2018, 05:36 PM
|
#5 |
|
Registered User
Join Date: Jan 2014
Location: Moreno Valley, Calif.
Posts: 244
|
Re: 1957 Bellhousing crossmember
On my 55 2nd V8 I cut the crossmember about 6in on each side, from the frame, and removed it. I have a full circle aluminum bellhousing and could not access the clutch with the crossmember in there. Like Mike, I have a crossmember at the rear of the trans and under the mid of the engine as well. Been a couple of years, and no problems yet....
__________________
'55 Chevy 1/2ton pickup w/ Pontiac 350 and Muncie M21 close ratio 4speed "Red Ryder" |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
