Fleetside rebuild - The 1947 - Present Chevrolet & GMC Truck Message Board Network

brianp01 · 09-13-2018, 10:15 AM

Hey guys I’m currently trying to rebuild my fleetside bed panels. They were rotted out pretty good around the rear support bracket, attachment areas. Previous owner had done the old bubblegum/flashing hodgepodge repair to these, so I’m kind of moving forward blindly. I have the panels separated and started making patch panels for these areas, was hoping somebody on here could help with some measurements for the bolt hole locations in this area or if anybody has a picture of the bedsides properly fitting the rear crossmember that would be super helpful.
Thanks,
Brian

09-13-2018, 10:15 AM	#1
brianp01 Registered User Join Date: Feb 2015 Location: New England Posts: 28	Fleetside rebuild Hey guys I’m currently trying to rebuild my fleetside bed panels. They were rotted out pretty good around the rear support bracket, attachment areas. Previous owner had done the old bubblegum/flashing hodgepodge repair to these, so I’m kind of moving forward blindly. I have the panels separated and started making patch panels for these areas, was hoping somebody on here could help with some measurements for the bolt hole locations in this area or if anybody has a picture of the bedsides properly fitting the rear crossmember that would be super helpful. Thanks, Brian Attached Images



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.