|
04-05-2019, 08:13 PM
|
#1 |
|
Senior Member
 
Join Date: May 2006
Location: Philadelphia, Pa. 19454
Posts: 9,762
|
trans pan
Any ideas on the value of torque required to attach the pan to the trans.? I'm thinking about the same as V/C. My gasket is only about a 1/16"
__________________
Semper Fi...Uncle Sam, you da man All parts offered to help are free, unless otherwise noted Dont try this stuff in my build thread, unless you have 55 years of mechanical OTJ training SAFETY FIRST AS usual, off topic They say your mind goes second, can't remember the first Jim |
|
|
|
04-05-2019, 08:47 PM
|
#2 |
|
Senior Member
Join Date: Dec 2006
Location: Studio City, Calif.
Posts: 2,886
|
Re: trans pan
1969 TH350; 110 inch pounds, TH400; 12 Ft. Lbs. You didn't say what you are working on.
__________________
'69 GMC C2500 Custom Camper, 8 1/2' bed, New GM 350, NP 435 Close Ratio 4spd. Trans., 3.73 Dana-60 open.Camper and Trailer wiring, PS, PB, AC, tach , three gas tanks, stereo speakers, 2nd owner, Work-Truck supreme. |
|
|
|
|
04-09-2019, 07:25 AM
|
#3 | |
|
Senior Member
Join Date: May 2006
Location: Philadelphia, Pa. 19454
Posts: 9,762
|
Re: trans pan
Quote:
__________________
Semper Fi...Uncle Sam, you da man All parts offered to help are free, unless otherwise noted Dont try this stuff in my build thread, unless you have 55 years of mechanical OTJ training SAFETY FIRST AS usual, off topic They say your mind goes second, can't remember the first Jim |
|
|
|
|
|
04-09-2019, 07:42 PM
|
#4 |
|
Account Suspended
Join Date: Jun 2015
Location: No longer here
Posts: 1,000
|
Re: trans pan
What type of pan gasket you using ? Paper ? Cork ? Rubber ? I have always used a speed wrench and tighten with experience.
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
