AK cross over steering arm - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**907burb** · 03-27-2020, 07:30 PM

I have a cross over steering arm, studs and lift block from a GM Dana 60. Great condition. I sand blasted and painted the arm and block. It came on a truck I parted out and I'm using the front axle. I believe it is missing the spacer, which I think is nothing more than a piece of 2 inch round stock. Looking for $85.00 shipped.

K20super · 03-29-2020, 01:20 PM

Is it set up for heim joints or tie rod ends?

**907burb** · 03-30-2020, 06:23 PM

I do not know. I'm not sure what the difference would be at the arm. Neither were connected to it when I brought the truck home.

03-27-2020, 07:30 PM	#1
907burb Active Member Join Date: Nov 2017 Location: Palmer, Alaska Posts: 198	cross over steering arm I have a cross over steering arm, studs and lift block from a GM Dana 60. Great condition. I sand blasted and painted the arm and block. It came on a truck I parted out and I'm using the front axle. I believe it is missing the spacer, which I think is nothing more than a piece of 2 inch round stock. Looking for $85.00 shipped. Attached Images

03-29-2020, 01:20 PM	#2
K20super Registered User Join Date: Nov 2016 Location: Center ND Posts: 73	Re: cross over steering arm Is it set up for heim joints or tie rod ends?

03-30-2020, 06:23 PM	#3
907burb Active Member Join Date: Nov 2017 Location: Palmer, Alaska Posts: 198	Re: cross over steering arm I do not know. I'm not sure what the difference would be at the arm. Neither were connected to it when I brought the truck home.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.