Wiper balance screws

[Asshat]

Can anyone tell me if these are the correct screws for the wiper valance?

[cwcarpenter98]

I think the factory ones were phillips head screws. That's what's on mine, but so many of them have rusted so bad, the head is almost gone!

[Asshat]

Originally Posted by cwcarpenter98

I think the factory ones were phillips head screws. That's what's on mine, but so many of them have rusted so bad, the head is almost gone!

I was thinking that too. I was not disciplined enough to store all the screws in Ziplocs. I do have some Phillip head screws , but I think the ones I tried were too small. They gotta be around here somewhere. Just thought I would see what everybody else has on their truck.

[val1gonzales]

These are the ones you need. They say 67-72 Hood-to-cowl seal retainer screw set. But they are the same as the ones used on my 66
http://www.truckandcarshop.com/trucks60_72/t60_094.html

[The Rocknrod]

Phillips.

[Asshat]

Originally Posted by val1gonzales

These are the ones you need. They say 67-72 Hood-to-cowl seal retainer screw set. But they are the same as the ones used on my 66
http://www.truckandcarshop.com/trucks60_72/t60_094.html

I just bought those and they are too small. Need the next size up in sheet metal screw.

Where exactly does the weatherstripping go? Is it attached to the valance or the hood?

[The Rocknrod]

Under the lip of the hood cowl.

[Asshat]

Originally Posted by The Rocknrod

Under the lip of the hood cowl.

So, I presume the notched part of the rubber goes under the wiper valance?

[spudder]

The notch is there to fit around the washer squirter nozzles.