Throttle Cable question - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Russell · 11-08-2004, 07:02 PM

Ok, as some of you may know, I am swaping to TPI, which requires that I put a longer throttle cable on so it'll reach the throttle body. Anyways, I bought a stock Camaro cable, but it's connection to the firewall is quite a bit different than the stock one. Is there some way that a guy can remove those two little "nuts" at the end of the cable to slide the cable out, cut off the camaro's firewall connector, then drill out the stock one and cement it to the new cable?

11-08-2004, 07:02 PM	#1
Russell Professional Grade Join Date: May 2003 Location: Fort McMurray, Alberta Posts: 7,915	Throttle Cable question Ok, as some of you may know, I am swaping to TPI, which requires that I put a longer throttle cable on so it'll reach the throttle body. Anyways, I bought a stock Camaro cable, but it's connection to the firewall is quite a bit different than the stock one. Is there some way that a guy can remove those two little "nuts" at the end of the cable to slide the cable out, cut off the camaro's firewall connector, then drill out the stock one and cement it to the new cable? __________________ 1995 Chevrolet 2 Door Tahoe (6.6L LBZ Duramax / ZF6 / NP241 with 1 ton solid axle swap)

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.