Headers for my '67 3/4Ton 4X4? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

redneck_motorsports · 12-24-2004, 02:49 AM

I have headers on mine and the only clearance problems I encountered were with the clutch linkage. I have a BBC in it and tried Hooker Headers first and absolutly could not make them fit. However Flow Tech, truck headers fit nicely with ample clearance except in the clutch cross shaft area. I had to dent the tube slightly to get it to clear but if your running an automatic I dont think you would have any problems, especially if you have a SBC as well.

Catfish

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

12-24-2004, 02:49 AM	#2
redneck_motorsports Registered User Join Date: Dec 2003 Location: Pampa Texas Posts: 36	I have headers on mine and the only clearance problems I encountered were with the clutch linkage. I have a BBC in it and tried Hooker Headers first and absolutly could not make them fit. However Flow Tech, truck headers fit nicely with ample clearance except in the clutch cross shaft area. I had to dent the tube slightly to get it to clear but if your running an automatic I dont think you would have any problems, especially if you have a SBC as well. Catfish



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.