![]() |
Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
![]() |
#1 |
Account Suspended
Join Date: May 2004
Location: Simi Valley, CA
Posts: 1,387
|
Bodywork progress 72 burb *56k beware*
Well, I sold the Mustang out at my parents house and I did not have a ride back to my place so I drove the burb back... I started getting tired of looking at all the dents in it and I decided to do something about it. Went to my buddies shop and used his stinger dent puller (the type where you fuse a rod to the body and pull the rod with the slide hammer to pull the metal back out) Pretty cool tool IMO...I also welded up some holes and welded a plate in to shave the sidemarker.
This was before ![]() yes thats duct tape over the sidemarker hole and a whole lot of bondo covering the damaged panel ![]() ![]() and After... ![]() Here is the truck just sitting at my place... Took it out and did this... ![]() ![]() ![]() It used to look something like this side before...This is going to be next Sunday's project. ![]() ![]() With this just about completely pulled I am just about ready to try to install the caddy lights I have. I think I might attempt this on my own... ![]() I also did a little work on this door. |
![]() |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|