Need help... removing gauge bezel! - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Russ72C10 · 08-12-2002, 08:06 PM

I'm getting frustrated. Trying to remove my gauge bezel to see if I can repair the printed circuit. I've got all the screws out of the bezel, wiper knob is off, headlight knob is off. Oil pressure line is undone. Wiring harness unplugged. Speedo is unhooked.

It's as if there's something holding it on TIGHT where the headlight & wiper knobs go into the dash.

Are there retaining nuts there? I can't feel any.

I'm definitely missing something... but I really am at a loss.

Could someone please steer me in the right direction? I wanna get this baby out before dark. (About 45 minutes to go!)

Thanks in advance!

08-12-2002, 08:06 PM	#1
Russ72C10 Four Wheeler Join Date: Jul 2002 Location: Decatur, IL Posts: 101	Need help... removing gauge bezel! I'm getting frustrated. Trying to remove my gauge bezel to see if I can repair the printed circuit. I've got all the screws out of the bezel, wiper knob is off, headlight knob is off. Oil pressure line is undone. Wiring harness unplugged. Speedo is unhooked. It's as if there's something holding it on TIGHT where the headlight & wiper knobs go into the dash. Are there retaining nuts there? I can't feel any. I'm definitely missing something... but I really am at a loss. Could someone please steer me in the right direction? I wanna get this baby out before dark. (About 45 minutes to go!) Thanks in advance! __________________ '84 K20 4x4 350 V8 - Weiand intake - Headers - 4" Tuff Country lift - 35x12.50 ProComp M/Ts on 15x10s

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.