|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
09-09-2005, 12:27 AM
|
#1 |
|
"Treasure the Ride"
Join Date: Nov 2001
Location: Mid Michigan, Harrison Michigan, USA
Posts: 682
|
Upper Control Arm Shaft Repair Need Help!
I need to replace the rubber boots (grease cups) on the upper control arm shafts of my wife's '63 C-10 Pickup. Question, will I be able to change the cups out without compressing the coil spring? Or will there be too much pressure on the upper control arm to do this with dealing with the coil springs. I want to be safe, but I do not have a compressor and would have to rent or buy one.
Any help is appreciated. Thanks! rico 
__________________
If you think you can you're right. If you think you can't you're still right. Trucks: '56 SWB; '57 SWB; '63 C-10 Current projects: 1963 Long Fleetside for the wife! '56 for the daughter. Visit us at: www.ricos-rods-and-relics.com |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode