|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
10-04-2005, 11:06 PM
|
#1 |
|
Registered User
Join Date: Jul 2003
Location: north of Phx AZ about 30 miles
Posts: 698
|
Different front end alignment question
I am about to put in my new, rebuilt, disk brake front end. I can figure out how to get a basic alignment on the truck as far as camber and toe in, but cant figure where, or how to measure for a caster adjustment. I figured at worst I could use a protractor to measure the current spindles between the two ball joints, then just apply that measurement to the new front end. I do wonder if there is an accurate way to get the exact measurement though?
Any suggestions? Thanks.
__________________
Andy,Phx AZ '67 C-10 (Ahhh, done at last. Well there is that disk front end I want to put in and...) "23 C-Cab-sold '48 Ford 8N tractor(still working) '67 Scout(Now on the road) '70 MG B.-sold |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode