Automatic to Standard swap? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Russell · 10-25-2005, 03:16 PM

Anyone here done a swap from an auto (TH400) to a standard (SM465) before?

Got pics, or any advice with regards to the swap?

I'm planning on leaving the automatic column in for now, I'll put a standard column in later. Clutch pedals will be from a 76 3/4 ton, but I don't have any linkages or anything yet (planning on going with a mechanical clutch for now)

I already know about the flywheel, clutch, pressure plate, etc, and I know how the linkage goes together, but I need advice on how to install the pedals into the truck, and how I should go about installing a removeable high hump into my cab (currently a un-removeable low hump)

10-25-2005, 03:16 PM	#1
Russell Professional Grade Join Date: May 2003 Location: Fort McMurray, Alberta Posts: 7,915	Automatic to Standard swap? Anyone here done a swap from an auto (TH400) to a standard (SM465) before? Got pics, or any advice with regards to the swap? I'm planning on leaving the automatic column in for now, I'll put a standard column in later. Clutch pedals will be from a 76 3/4 ton, but I don't have any linkages or anything yet (planning on going with a mechanical clutch for now) I already know about the flywheel, clutch, pressure plate, etc, and I know how the linkage goes together, but I need advice on how to install the pedals into the truck, and how I should go about installing a removeable high hump into my cab (currently a un-removeable low hump) __________________ 1995 Chevrolet 2 Door Tahoe (6.6L LBZ Duramax / ZF6 / NP241 with 1 ton solid axle swap)

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.