|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
09-02-2002, 09:10 PM
|
#1 |
|
Used to have a truck
Join Date: May 2002
Location: port orchard WA
Posts: 1,552
|
Shifter renew question
I just pulled the shifter handle out. I'd have to say that once I figured out that only the outer collar has to turn it was a snap to take out. Anyway there is a roll pin at the end of the shaft. The hole that the roll pin passes through looks sloppy ( the outer collar ). Should that be a tight fit? Shoud I ream it out for a larger OD pin. will that tighten my shifter play up?
__________________
No truck :-( |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode