Source for junction block connectors? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Russell · 02-19-2006, 10:40 PM

Howdy!

I've finally got my GMC's electrical sorted out to the point that I am ready to start hooking stuff up. However, I want to route some new wires through the junction block instead of routing it through grommets in the firewall, and have found it nearly impossible to re-use those pins. Their tabs just snap off at the slightest bit of movement, even if you apply lots of heat.

Does anyone know if anyone sells those pins aftermarket? I need like 15 of them, and the HELP! section dealies are 2 bucks a peice :eek1:

Anyone have any suggestions? Or should I just do the ol' through the grommet type connections?

02-19-2006, 10:40 PM	#1
Russell Professional Grade Join Date: May 2003 Location: Fort McMurray, Alberta Posts: 7,915	Source for junction block connectors? Howdy! I've finally got my GMC's electrical sorted out to the point that I am ready to start hooking stuff up. However, I want to route some new wires through the junction block instead of routing it through grommets in the firewall, and have found it nearly impossible to re-use those pins. Their tabs just snap off at the slightest bit of movement, even if you apply lots of heat. Does anyone know if anyone sells those pins aftermarket? I need like 15 of them, and the HELP! section dealies are 2 bucks a peice :eek1: Anyone have any suggestions? Or should I just do the ol' through the grommet type connections? __________________ 1995 Chevrolet 2 Door Tahoe (6.6L LBZ Duramax / ZF6 / NP241 with 1 ton solid axle swap)

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.