|
upper A-Arm stud issues
I'mn currently in the process of putting tube A-arms on my '67 C-10. I have replacement studs which attach the upper A-arm to the frame mount. The original studs are slightly smaller in diameter than the replacements. The original arms had a fair amount of clearance and the new arms have even more play on the old but fit pretty well on the new set. If I drive out the old studs it looks like I will need to drill the holes out to fit the new bolts.
Can I leave the old studs in place or will the excessive clearance cause problems even after everything is snugged up?
__________________
67 Stepside 468 BBC Built by me @ Texas Engine Machine in Llano, TX. Modified 700R4, 12-bolt 3:73 ..Exactly when did I decide that I could spend more than I make?  "The more I think about it, old Billy was right..."
|
03-10-2006, 01:28 PM
Threaded Mode