Diamond Plate bed floor for a '68 short fleet... - The 1947 - Present Chevrolet & GMC Truck Message Board Network

T J Randall · 06-02-2006, 06:49 PM

Hi ya'll from Ponder, Tx. I'm considering this idea as an alternative 'cause going to wood at this time is cost prohibitive. The steel floor is trashed and I already picked up a steel floor front bed wall. Lookin' for some ideas and support from the membership as to the easiest way to go about this. Cardboard template, or use the old floor piece flipped over on the plate, etc.. Any suggestions, (please .. no cussin') will be appreciated.

06-02-2006, 06:49 PM	#1
T J Randall Junior Member Join Date: Dec 2005 Location: Ponder, Tx. Posts: 19	Diamond Plate bed floor for a '68 short fleet... Hi ya'll from Ponder, Tx. I'm considering this idea as an alternative 'cause going to wood at this time is cost prohibitive. The steel floor is trashed and I already picked up a steel floor front bed wall. Lookin' for some ideas and support from the membership as to the easiest way to go about this. Cardboard template, or use the old floor piece flipped over on the plate, etc.. Any suggestions, (please .. no cussin') will be appreciated.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.