Were to put an oil temp sensor? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Edmond · 06-15-2006, 05:51 AM

Well the title says it all basicly.
I've tried the oil pan, but it leaked a little bit and I wanted to tighten it a bit more but it broke off,
leaving me with a lot of cleaning to do on the floor in front of my house

The adapter plug broke in half. The part that was still inside the oilpan I luckely got it out without any problems.
So is there any other place where I can put this oil temp sensor in a Small Block?
Thanks in advance for any ideas.

Cya,
Edmond
Dutch Longhorn

06-15-2006, 05:51 AM	#1
Edmond Registered User Join Date: Jan 2000 Location: The Netherlands Posts: 1,063	Were to put an oil temp sensor? Well the title says it all basicly. I've tried the oil pan, but it leaked a little bit and I wanted to tighten it a bit more but it broke off, leaving me with a lot of cleaning to do on the floor in front of my house The adapter plug broke in half. The part that was still inside the oilpan I luckely got it out without any problems. So is there any other place where I can put this oil temp sensor in a Small Block? Thanks in advance for any ideas. Cya, Edmond Dutch Longhorn __________________ 1971 Chevy C/20 Longhorn, 350/TH400, Edelbrock Performer, IMPCO 425 LPG Carb 1974 Chevy Camaro Z28 (Original) ------------------------- The Netherlands

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.