5x5 to 5x4.75 bolt pattern? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

11-02-2006, 11:49 PM

#28

SCOTI

Registered User

Join Date: Apr 2001

Location: DALLAS,TX

Posts: 22,066

Re: 5x5 to 5x4.75 bolt pattern?

Quote:

Originally Posted by stepn67

Yeah your right, the S10 ball joints probably would'nt hold up.
I just called a local parts house and the front wheel bearings for an 85 C10 are the same as the bearings on an 86 S10. So i guess the rotors are what my buddy used on his 66.

This might be possible.....BUT, this route also forces you to decrease the braking ability of the truck because an S10 front rotor is only 10.5" dia vs the trucks 12" dia.

Re-drill the truck rotors.

__________________
67SWB-B.B.RetroRod
64SWB-Recycle
89CCDually-Driver/Tow Truck
99CCSWB Driver
All Fleetsides
@rattlecankustoms in IG

Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive.
It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar.....

Cubic inches is like Indiana Jones with a cheap pistol.

Bookmarks

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Forum Jump

All times are GMT -4. The time now is 12:30 AM.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.