|
01-09-2007, 11:03 PM
|
#1 |
|
Registered User
Join Date: Feb 2003
Location: Holland Pa.
Posts: 76
|
Inner Tie rods?
Hey All,
I just finished rebuilding the front suspension on the Blower Truck ran into a "Little" problem at the very end. The truck is a 72 C10 power steering,brakes etc. Now the problem, the inner tie rod I have which was purchased for onother project truck was I believe ordered for a 71-72 C10 PS,PB but the diameter of the stud is .580 and the drag link is .480 meaning the new rod won't freakin fit. The inner rod is the smaller diameter stud as is the drag link, both inner/outer mounting points are the small dia. So I call my Nephew he runs a local parts store and give him all the pertinent info on the truck he says yeah got em in stock so I go to pick them up they are the bigger stud also so what the hell, is the drag link off a different year truck the mounting holes are the same size. I am not to good at explaining my thoughts written down so if anyone gets the drift of this problem Help!!! Thanks in advance
__________________
1970 C10 Stepside (soon to be a 68 w/PS/PB/S&W back-half narrowed F**D 9inch w/Discs) 66 427/435 corvette motor (hopefully 871 Blower) 66 M21 4 speed (swapped in a built TH400) 31/16.5/15 Mickeys (soon to be 29.5X18.5X15 MT) 1972 C10 Stepside Pro-Street 1988 bed 3" Top Chop Custom Red Pearl paint w/overlapping Ghost Flames P/S P/W P/B P/DL P/door open Everything Shaved Frenched antenna 461CI BBC BDS Blower 1100 Dynoed HP TH400 Super Heavy Duty Full Back-Half Narrowed 12 Bolt 4:10 |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode