Help needed on 1955.5 to 1959 bed. - The 1947 - Present Chevrolet & GMC Truck Message Board Network

CAL 58 GMC · 03-15-2007, 10:07 PM

Hey Guy's,

When I bought my truck the bed it came with was so rusty I had to scrape it and go for a new one. The problem is, the new bed sides I bought have no hole in them at all. So I was wondering if any of my trucking buddies out there could take some measurements for me. Here’s what I need:
• From the very front of the bed side to the first bolt hole for the fenders.
• From the very front again, the measurement for the center each bolt hole on the floor rail attached to the bed side.

Photo would be a great help also. Any help will be greatly appreciated!

03-15-2007, 10:07 PM	#1
CAL 58 GMC Senior Member Join Date: Jun 2005 Location: Clovis Ca. Posts: 3,311	Help needed on 1955.5 to 1959 bed. Hey Guy's, When I bought my truck the bed it came with was so rusty I had to scrape it and go for a new one. The problem is, the new bed sides I bought have no hole in them at all. So I was wondering if any of my trucking buddies out there could take some measurements for me. Here’s what I need: • From the very front of the bed side to the first bolt hole for the fenders. • From the very front again, the measurement for the center each bolt hole on the floor rail attached to the bed side. Photo would be a great help also. Any help will be greatly appreciated! __________________ Classic Trucks Link http://www.classictrucks.com/feature...uck/index.html 1958 GMC.Project Build http://67-72chevytrucks.com/vboard/s...d.php?t=162816 1966 Chevelle Build http://67-72chevytrucks.com/vboard/s...d.php?t=443576 Video http://www.youtube.com/watch?v=prrNKo8F7Zw#GU5U2spHI_4 Last edited by CAL 58 GMC; 03-15-2007 at 10:14 PM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.