1967 Firewall hole identification - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Joe67 · 03-27-2007, 01:02 PM

I am preparing to have the metal work done to my cab (finally).

I am going smooth. I have already purchased the 3 pieces to block off the heater openings. I assume the smaller holes around those can be welded up as well.

I'm looking for some ID on the remaining holes across the firewall so I know what can go and what needs to stay.

I will run a factory steering column setup with an automatic transmission. Probably mounted on the steering column. I will run a vintage AC setup.

Thanks Guys

03-27-2007, 01:02 PM	#1
Joe67 67 is sold Join Date: Apr 2001 Location: Troy, Michigan Posts: 6,733	1967 Firewall hole identification I am preparing to have the metal work done to my cab (finally). I am going smooth. I have already purchased the 3 pieces to block off the heater openings. I assume the smaller holes around those can be welded up as well. I'm looking for some ID on the remaining holes across the firewall so I know what can go and what needs to stay. I will run a factory steering column setup with an automatic transmission. Probably mounted on the steering column. I will run a vintage AC setup. Thanks Guys __________________ Joe - Formerly 67c10step ------------------------------- 1967 Chevy Stepside - ECE 4/6, fuelcell, 5lug - SOLD gr8lakes - My ebay auctions Click here to order forum apparel :: Click here to become a subscribing member

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.