Where can I get a serpentine setup? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

jackyl9999 · 06-04-2007, 12:43 AM

Ive got to figure out a way to get a pulley set up for my 70 gmc. It has a 350 with heads off a pre vortec engine. The engine is new to me. Ive looked in jegs and summit and I need to find something cheaper than what they have. I plan on running a/c and it already has a water pump on it. Could i make something work out of a junk yard? The pic I have of the engine is not the best angle but the truck is 40 miles from here so this is the only one I have.
thanks for any info or ideas.

06-04-2007, 12:43 AM	#1
jackyl9999 Registered User Join Date: Feb 2003 Location: Paragould, Ar Posts: 571	Where can I get a serpentine setup? Ive got to figure out a way to get a pulley set up for my 70 gmc. It has a 350 with heads off a pre vortec engine. The engine is new to me. Ive looked in jegs and summit and I need to find something cheaper than what they have. I plan on running a/c and it already has a water pump on it. Could i make something work out of a junk yard? The pic I have of the engine is not the best angle but the truck is 40 miles from here so this is the only one I have. thanks for any info or ideas. Attached Images __________________ 1970 Gmc Grande Sierra Swb 2wd LSX (LQ4/4L80e) 1990 K1500 Daily

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.