|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
11-08-2007, 10:53 PM
|
#1 |
|
Registered User
Join Date: Apr 2006
Location: Lincoln Ca.
Posts: 6
|
72 Longbed Drive Shaft
I just removed the drive shaft from my truck to replace the carrier support and bearing. I removed the back half of the shaft . do I need a bearing puller to remove the old bearing and cut the ruber remains from the old support?
I am open to you suggestions. I dont remember using a bearing puller or any special tooling when I had my 58' Belair 2 peice shaft. Am I losing my mind. |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode