bell housing to transmission alignment - The 1947 - Present Chevrolet & GMC Truck Message Board Network

The 1947 - Present Chevrolet & GMC Truck Message Board Network

Click Here



Register or Log In To remove these advertisements.

		The 1947 - Present Chevrolet & GMC Truck Message Board Network > 47 - Current classic GM Trucks > The 1967 - 1972 Chevrolet & GMC Pickups Message Board
bell housing to transmission alignment

Site Merchandise

Mark Forums Read

Prev

Previous Post

Next Post

Next

01-11-2008, 06:31 PM	#1
prg machine Registered User Join Date: Jun 2007 Location: oregon Posts: 1,069	bell housing to transmission alignment I have a standard shift cast iron bell bolted up to my small block and the indicator is reading .015 TIR ( total indicator runout) by mounting to the crank and spinning in transmission bore. i know about the offset dowel cure.................is .015 too much? what should I shoot for? Thank you.

Bookmarks

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Forum Jump

All times are GMT -4. The time now is 05:55 AM.