|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
07-19-2008, 10:40 PM
|
#1 |
|
Registered User
Join Date: Jun 2007
Location: oregon
Posts: 1,069
|
Window handles are ridiculous
I am finishing up my window regulator instalation and I can't believe how little spline engagement that there is on the window crank handles . The splines are considerably longer but only about 1/8 of an inch actualy engages. Are there improved aftermarket versions? Or is this the name of the game? Seems like a real design flaw.
I actualy thought about grinding back the "point" of the regulator shaft to allow more engagement and drilling and tapping for a small flat head srew to hod the handles on, this of course would put the handle on farther and screw up the spacing for the estuchion behind the handle. ... I am also pretty sure that regulator shaft is probably harder than the hubs of h*** .................has anyone else come up with an improved window crank or some backyard method to improve this situation? Thanks once again.
__________________
69 K-20 cloned to a 67 with front clip and some other stuff. 383 .040 over Crane roller cam lifters and rockers ,1.6 intake ratio, Open chamber heads, 9.5-1 compression ratio, 2.02 intake valves , Edelbrock performer Air Gap manifold Carter AFB performer 750cfm, MSD ignition, SM465 NP205 4.10 gears: 
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode