Opinions on LMC sheet metal or other suggestions? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

m6z · 11-25-2008, 01:16 PM

I'm going to be ordering a new short fleet bed for the short step truck that I recently bought. Plus a fender and a pair of inner fenders.

Anyway have any of you used the complete bed from LMC? How was the fit? Would you buy from them again? If not who do you recomend that I should deal with?

The truck is going to be built in kansas, so I could drive up to LMC to save on the shipping cost, but I don't want to buy poor fitting crap either.

Thanks for the help,
Doug

11-25-2008, 01:16 PM	#1
m6z Registered User Join Date: Aug 2008 Location: Pittsburg, KS Posts: 2,466	Opinions on LMC sheet metal or other suggestions? I'm going to be ordering a new short fleet bed for the short step truck that I recently bought. Plus a fender and a pair of inner fenders. Anyway have any of you used the complete bed from LMC? How was the fit? Would you buy from them again? If not who do you recomend that I should deal with? The truck is going to be built in kansas, so I could drive up to LMC to save on the shipping cost, but I don't want to buy poor fitting crap either. Thanks for the help, Doug Last edited by m6z; 11-25-2008 at 03:30 PM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.