Man, what a job! - The 1947 - Present Chevrolet & GMC Truck Message Board Network

CAMAROSS · 12-24-2008, 07:47 PM

I just completed installation of the Western Chassis 4" drop system on the back and Im waiting on the arrival of the 2" drop spindles for the front. I ordered all of it at the same time but the spindles still havnt made it yet.
I tell you what, you guys are probably alot better mechanically than me but removing those leaf holders was a pain. Grinding off those studs and the gas tank is in the way too. Its looking good though. When I get the spindles on, I will post pics. Any tricks on installing the new spindles before I get started?

12-24-2008, 07:47 PM	#1
CAMAROSS Registered User Join Date: Jan 2007 Location: Sulphur Springs, Tx Posts: 100	Man, what a job! I just completed installation of the Western Chassis 4" drop system on the back and Im waiting on the arrival of the 2" drop spindles for the front. I ordered all of it at the same time but the spindles still havnt made it yet. I tell you what, you guys are probably alot better mechanically than me but removing those leaf holders was a pain. Grinding off those studs and the gas tank is in the way too. Its looking good though. When I get the spindles on, I will post pics. Any tricks on installing the new spindles before I get started?

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.