|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
01-16-2009, 12:38 AM
|
#11 |
|
Registered User
Join Date: Apr 2001
Location: DALLAS,TX
Posts: 22,080
|
Re: you want to change your 5X5 bolt pattern on 73-87 disc to 5X4.75
Ahhh.... The numbers may not mean anything then (because of the different calipers). The set-up I have is OE S10 (11" rotors IIRC) w/OE rear emergency brake.
I have everything minus one rotor that my buddy mis-placed some where along the line. I'll try & grab a rotor & put it inside a wheel & measure from the wheel 'pad' to the inside rotor surface (right?).
__________________
67SWB-B.B.RetroRod 64SWB-Recycle 89CCDually-Driver/Tow Truck 99CCSWB Driver All Fleetsides @rattlecankustoms in IG Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive. It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar..... Cubic inches is like Indiana Jones with a cheap pistol. |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode