The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > 47 - Current classic GM Trucks > The 1947 - 1959 Chevrolet & GMC Pickups Message Board

Web 67-72chevytrucks.com


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 03-23-2009, 02:11 PM   #1
Houston54
Registered User
 
Join Date: Feb 2005
Location: location
Posts: 527
1954 C-Notch Modification

One of the many differences the 1954 truck has from the earlier models is the rear portion of the frame was redesigned for the new box style. This required the Kick-up over the rear axle to be reduced significantly. This is not a big deal unless you are running leaf springs and lower the truck beyond 6 inches which I have done.

My set up included the stock rear leafs swapped end to end with two leaves removed, 2.5" lowering blocks, axle flip, and the front spring hanger swapped out for the shorter one from the front suspension. All told this gave me about 7 inches off the stock height and left me with an axle to frame interference on larger bumps/dips and a rather bucky ride. Not something I wanted to live with.

The typical solution is to install a C-notch in the frame and install a 4-link/parallel bars/triangulated link/etc suspension set up with coilovers or air ride.

Not what I wanted to do this truck.

I wanted to retain the leaf springs but upgrade them and increase the suspension travel at the back. This would require a C-notch but the 54 frame is only 3.5" tall and 2.25 wide in the area over the axle. Not a whole lot of meat to work with.

To resolve this I designed a notch that would give me an additional 2 inches of travel and would retain the frame strength so using leaf springs would not be a problem.

The notch uses 3/16 and 1/4 material and relies on the use of doubler plates on the top and sides to provide additional strength.

The rear springs will be replaced with new units from Posies. They have stock replacement units that are rated for 400 HP and are designed to move the rear axle 3 inches rearward to center the wheel in the fender. I had previously accomplished this by flipping the axle end to end and having a 1.5 inch offset on the lowering blocks. The new springs will enable me to get rid of that and use the driveshaft I now have.

Here are some pics of the modification. There is a more complete write up on my picturetrail album:

http://www.picturetrail.com/sfx/album/view/21770193
Attached Images
     

Last edited by Houston54; 03-24-2009 at 08:26 AM.
Houston54 is offline   Reply With Quote
 

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 10:37 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com