Started making my wishbone

[Tri5Nerd]

Tell me what you think of the construction.
Tubing is 1.25" OD, .25" wall DOM.
Angle is 47* at the front and 19" to the 50* bends.

I need to cut about 3" off the part that will sit on the axle.
Did this is welding class tonight using the tube notcher and bender and TIG.
Third time using the TIG, been doing more Gas and stick, stick is hard to do overhead.

I'll make some gussets and brackets to go on the axle next week.
What size bushings should I get for this setup?

Tri5