|
06-27-2009, 08:41 PM
|
#1 |
|
People know me
Join Date: Jun 2007
Location: Hermiston, oregon
Posts: 840
|
My Rear Bumper How-to
I have gotten alot of requests about who made my bumper, I did. So here is my how-to, This has been an extremely good bumpe to me and has held up to a ton of pulls and winch-outs without fail.
I used a plasma to cut out the angles on the c-channel, but a cut-off wheel, sawsall, torch or whatever would be fine too. I smoothed over all the welds with a 60grit sanding disc then primed and rattlecanned black. I tapped all the license plate bolt holes with a 1/4-20 tap.    
__________________
1972 k/5 blazer CST 4X4 Crate 350, th350/205, dana44with trac-loc/14 bolt with detroit locker, 4 wheel discs 4.56s, 8" suspension lift using 73-87springs, 1" zerorate custom front crossmember, HAD CV drivelines and driveshaft e-brake, full cage, PRP seats, Full autometer gauges, 38x14.5x16 Toyo M/Ts, 16x10 Polished aluminum rockcrusher wheels 1967 longbox 4x4, Strong 400/400/208, 44/12bolt 4.10s, 6" lift, 35" Toyo M/Ts on corvette rally wheels |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode