|
10-03-2009, 07:44 PM
|
#1 |
|
The oddest Todd around
Join Date: May 2004
Location: Miami, Florida
Posts: 1,418
|
JB weld question
OK...
So... I am using the carb studs on my aluminum edelbrock intake, but have unfortunately stripped one of them out. (guess the carb came off one too many times) So here is the question... can I just put a little JB weld on the threads of the stud and screw it into the intake manifold? Will I then be able to torque the carb down. The reason I ask is because I'm pretty sure that I have a vacuum leak (surging and trouble idling and stuff), and I'm thinking it's because I can really only clamp down on 3 out of 4 of the studs... So... opinions? Oh... I also have some red locktite... if that'll work too.......................
__________________
"The greatest pleasure is to vanquish your enemies and chase them before you, to rob them of their wealth and see those dear to them bathed in tears, to ride their horses and clasp to your bosom their wives and daughters." Ghengis Khan IIOY??? Last edited by toddtheodd; 10-03-2009 at 07:46 PM. |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode