|
Upper ball joint question
So I ordered a power disc setup with drop spindles from POL. The bottom ball joint slid into the spindle and I was able to put the casel nut on with no problems. The upper ball joint on the other hand I had to crank the hell out of to get the castle nut up far enough to get the cotter pin in. I mean I literally had to use a breaker bar to turn the nut so no way does it meet the factory tq specs. The spindle does move freely though. Should I be concerned with this?
The nut is on there and locked into place, but don't know what kind of problems I may have.
|
10-05-2009, 05:33 PM
Threaded Mode